Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Removing seat backs to replace securing clips.

Discussion in 'VT - VX Holden Commodore (1997 - 2002)' started by berlina phantom, Mar 29, 2012.

  1. Mar 29, 2012 #1
    berlina phantom

    berlina phantom New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Mar 29, 2012
    Location:
    Winston Hills
    Members Ride:
    VT Berlina
    Probably simple but just bought a VT Berlina (in great original nic) & not too savvy.How do you remove the plastic covers holding map pocket to replace the broken securing clips? Search hasn't directed me to any threads.
     
    berlina phantom, Mar 29, 2012
    #1
  2. Mar 30, 2012 #2
    acarmody

    acarmody Donati..Whoa Green

    Messages:
    5,920
    Likes Received:
    43
    Trophy Points:
    48
    Joined:
    Apr 29, 2007
    Location:
    Brisbane
    Members Ride:
    VX Berlina
    Pull out a bit from the bottom, then down. Normally if the clips are broken they just fall out.
     
    acarmody, Mar 30, 2012
    #2
  3. Mar 30, 2012 #3
    som

    som New Member

    Messages:
    400
    Likes Received:
    2
    Trophy Points:
    0
    Joined:
    Apr 12, 2011
    Location:
    thorneside qld
    Members Ride:
    vt executive
    be careful pushing the seat back back in place again after you've replaced the clips.If they're not all correctly aligned you'll have to remove the panel again which means that you have replace the clips again cos they're not re-useable.can become a bit expensive.4 hands may be better than 2.
     
    som, Mar 30, 2012
    #3

Share This Page