JamesSap
Member
- Joined
- Feb 3, 2022
- Messages
- 30
- Reaction score
- 8
- Points
- 8
- Age
- 24
- Location
- Australia
- Members Ride
- Vt S pack s1
Gday guys,
I am currently in the middle of restoring my 98 vt spac. I have purchased 4 new door glass panes for the car, and im having trouble installing them. I did a practice run on an old door i had and it went okay, but my main struggle points are the front guide rail and the rubber seal, specifically the corner of the door. I cannot separate the old glass from the front rail no matter how hard i push, pry or wiggle. All the info i have found including repair manuals just states to "remove glass runners from guide rail" and i cannot seem to figure out how to do it. The corner seal isnt wanting to seat either, it is acting almost as if its too long or possibly stretched. Any information would be super helpful, thanks guys.
I am currently in the middle of restoring my 98 vt spac. I have purchased 4 new door glass panes for the car, and im having trouble installing them. I did a practice run on an old door i had and it went okay, but my main struggle points are the front guide rail and the rubber seal, specifically the corner of the door. I cannot separate the old glass from the front rail no matter how hard i push, pry or wiggle. All the info i have found including repair manuals just states to "remove glass runners from guide rail" and i cannot seem to figure out how to do it. The corner seal isnt wanting to seat either, it is acting almost as if its too long or possibly stretched. Any information would be super helpful, thanks guys.