Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

stateman power hose replacement

Discussion in 'VT - VX Holden Commodore (1997 - 2002)' started by umair, Feb 8, 2012.

  1. umair

    umair New Member

    Messages:
    286
    Likes Received:
    4
    Trophy Points:
    0
    Joined:
    Jul 29, 2011
    Location:
    saudi arabia
    Members Ride:
    Sold my car :(
    I have wh statesman and the short hose of the power steering reserviour leaks very slowly. I have to top it up every two weeks. I live in saudi arabia and they do not have any hose in stock. I tried a heater hose but it got bended where it curves. What kind of hose can I use. Heater hose will not work. I need something flexible.
     
  2. ben315vz

    ben315vz Donating Member

    Messages:
    1,466
    Likes Received:
    18
    Trophy Points:
    38
    Joined:
    May 11, 2011
    Location:
    Tamborine Mountain, QLD
    Members Ride:
    '05 Holden VZ Calais V8
    Try tightening the hose clamps?
     
  3. SavVYute

    SavVYute Active Member

    Messages:
    1,330
    Likes Received:
    18
    Trophy Points:
    38
    Joined:
    Nov 26, 2009
    Location:
    Townsville
    Members Ride:
    VY S V6 Ute Series II 2004
    The original Holden power steering hoses are specially shaped to suit and are reinforced inside with a coil.
    Sometimes you can be lucky and stop the leak by tightening the hose clamp (if your leak is at a join) but what usually happens is the hose clamp is tightened so much that the clamp distorts out of round and leaks as bad if not worse no matter how much you tighten it. The hoses have just enough length to reach so chopping a bit off and retightening isn't an option.
    I replaced both hoses recently here in OZ and it cost about $30 for one and $20 for the other shorter one (from Holden).

    Can you get your dealer to order the hose for you?
     
  4. NSTG8R

    NSTG8R Member

    Messages:
    168
    Likes Received:
    2
    Trophy Points:
    18
    Joined:
    Jun 15, 2008
    Location:
    SA
    Members Ride:
    HSV Maloo R8 + VX Berlina 5.7
    try transmission cooler hose. Should be able to bend it close to the original shape so that it'll fit
     

Share This Page