Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Step By Step Guide for Replacing the Crank Angle Sensor (CAS) on an RB30

treezey

New Member
Joined
Sep 14, 2008
Messages
39
Reaction score
1
Points
0
Location
Hobart
Members Ride
VR 5-spd BT1
if therez 6 or so markings on the balancer which on do i stop at? wich ones tdc
 

detox_nath83

Another VL Driver
Joined
Aug 6, 2005
Messages
2,160
Reaction score
6
Points
0
Age
40
Location
Queensland(Sunny Coast)
Members Ride
VL Turbo Commo
clean your balancer and use a bright torch it is definently there.

To make it nice and bright put "white out" either side of the grooves not in them it willl make it easy to read.

Also you can get a compression gauge and push car over till cylinder 1 is at TDC and then slide in dizzy with rotor arm facing 1 then timing light to fine tune
 

Attachments

  • DSC00134.jpg
    DSC00134.jpg
    80.5 KB · Views: 3,002

detox_nath83

Another VL Driver
Joined
Aug 6, 2005
Messages
2,160
Reaction score
6
Points
0
Age
40
Location
Queensland(Sunny Coast)
Members Ride
VL Turbo Commo
if therez 6 or so markings on the balancer which on do i stop at? wich ones tdc



Far Left Mark is 0deg and go up in 5 deg increments.

Middle mark is 15deg btdc. (Factory) so put it roughly around 15-17 then fine tune where your car like it best for performance low/top end :p
 

Oknil

New Member
Joined
Jan 20, 2014
Messages
1
Reaction score
0
Points
0
Age
41
Location
Melbourne
Members Ride
Vl turbo
All good with the guide is very good just having trouble removing the first metal collar holding metal disc on is there a trick or sumfin
 
Top