SV5000 GTS 5000i and Group A brake caliper 330 adaptor specs wanted!

[UNLEASHED]

Hey all looking for bolt centre/ diameters and step offset hub mount/caliper in order to make a set of billet steel adaptors at an engineers workshop. Any help appreciated!

 

[UNLEASHED]

Anybody at all?? Its not to make money but just to make a set for personal car- Cheers...

 

[Deuce]

I would help if I could.
But you know the stock hole centres, and you know the centres of the new calipers, so really just need to sit it up there (with pad central in contact patch area) and do some careful and accurate measurement.

Make a cardboard template. Make a wooden template. Anything to help you get it exactly where it needs to be so the engineer has foolproof info to go off of.
Tech drawing would be the best though (and as you say, someone must have one somewhere)

 

[UNLEASHED]

Cheers mate- Yes done that part and saving for 330 vn vp type discs/hub assys and made a 5mm ally piece and will pack washers either way to get an offset measurement...Would prefer to have life made easier by just having to correct measurement...lol.

 

[Immortality]

Those drawing probably gut rubbished when Holden got shut down. Just like the blue prints for the GRP A manifolds

 

[ephect]

I can get you the measurements, but you have to wait until the weekend for me to pull one off

 

[UNLEASHED]

That'd be awesome- Thanks mate!

 

[Deuce]

I can get you the measurements, but you have to wait until the weekend for me to pull one off

I'll be keen too.
My mate has 330mm rotors for his VP and is hunting for calipers (at a reasonable price) so will obviously also need the measurements.

 

[ephect]

No worries gents

im going to take this opportunity to replace pads so it's timely

 

[UNLEASHED]

I'll be keen too.
My mate has 330mm rotors for his VP and is hunting for calipers (at a reasonable price) so will obviously also need the measurements.

LOL...I have 2 sets of calipers but no discs yet....