Torque settings for 202 rebuild

[AaronW12b]

As the title says, just need the torque specifications for the Mains Caps, Conrod Caps and Head bolts please
TIA

 

[Vin999]

depends what brands your using in parts,bolts, gaskets, manufacturerers have their own torque specs, the old holden torques 75 head, 70 mains and 35 caps last stage rings a bell.

 

[vc commodore]

Mains 95NM
Cons 48 NM
Head 1st stage 54NM
2nd stage 102NM

When you get the head gasket, the torque settings are also on the packet.

If you need FT/LB settings holla and I'll post them up

These are the torque settings I used recently on a 3.3 that I recently replaced the bearings and head...

I got them from both Elleries and Gregories manuals

 

[Smitty]

.. from the genuine Holden engine manual covering 202 L6 and all V8 engines

 

[Vin999]

As the title says, just need the torque specifications for the Mains Caps, Conrod Caps and Head bolts please
TIA

the old holden torques 75 head, 70 mains and 35 caps last stage rings a bell.

Those last torque figures I mentioned above are the old pounds foot used years ago....
75 head = 102Nm ....70 mains = 95Nm ....35 caps = 48Nm ....
Whether you have and/or using an old lbs/ft or digital Nm torque wrench.
No need to tell you how to torque up in stages to final figure in assembly, one would assume you know how to do that.