bezz
Member
In your case mate id run at least 4ga (5.19mm diameter) power to a distribution block, which would then split to 8ga to all of your amps. From there earth each amp to the chassis with 8ga (3.26mm diameter).
Here's an example of a fused distribution block:
http://www.jaycar.com.au/productView.asp?ID=SZ2070&keywords=distribution+block&form=KEYWORD
Here's a good American Wire Gauge to mm conversion table:
AWG to square mm Wire Gauge Conversion
Here's an example of a fused distribution block:
http://www.jaycar.com.au/productView.asp?ID=SZ2070&keywords=distribution+block&form=KEYWORD
Here's a good American Wire Gauge to mm conversion table:
AWG to square mm Wire Gauge Conversion