unknown wiring

[GG5.7]

Hi fellow commodore enthusiast, could any one tell me were this wiring connects to on my vu?
and its not the horn wire.

 

[krusing]

It looks like a piggy back slide spade terminal,
Bonnet latch switch ?
Air Temp Sender ?
Receiver Dryer connector ?
Additional Fan for the condenser ?

May need to get a wiring diagram and look for the colour code of the cables.

For the case of the exercise, wrap some insulating tape around it so it doesn't short out to ground/body.

 

[lmoengnr]

Part of an aftermarket alarm system?

 

[gtrboyy]

My guess is for alarm system or idot light if they have it.

See that black bracket in middle next to wear bonnet catch is probably has little plastic button/spring combo like in door jambs.

 

[wildfiremaint]

Yes that black bracket is missing its
switch. Probably part of bonnet alarm.
Get a new sw. from Jaycar if you need to reinstate the alarm.

 

[Fu Manchu]

It looks like the bonnet switch.
Unscrew the bonnet switch next to that circle part and see if there’s any wiring attached to it. Otherwise, that’s where it belongs.

 

[Fu Manchu]

Here’s the one off mine (before I cleaned it up)

 

[GG5.7]

Thanks for sorting that out, I'll investigate it further after I get my ute back from paint shop.

 

[Fu Manchu]

That sub loom goes inside the upper radiator support beam. that bracket is missing the button.