Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

VE airconditioning rotary vent dial not operating on dash

Discussion in 'VE Holden Commodore (2006 - 2013)' started by David egan, Feb 16, 2013.

  1. Feb 16, 2013 #1
    David egan

    David egan New Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Feb 16, 2013
    Location:
    Newcastle
    Members Ride:
    ve
    Hi all
    The title pretty much says it all , air conditioning is stuck on lower feet mode no matter where dial is rotated the venting does not change, any suggestions on solutions? All other parts of the system work still have fan control /hot cold etc
    Regards
    David
     
    David egan, Feb 16, 2013
    #1
  2. Feb 23, 2013 #2
    bkm2009

    bkm2009 New Member

    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Jan 28, 2012
    Location:
    Perth. WA
    Members Ride:
    VE Omega & VE Berlina
    thread bump, mine is stuck aswell, but on front Demist. all hoses in engine bay are on correctly, have tried relearn by holding rear demist button.
    Any ideas?
    Cheers
    bkm2009
     
    bkm2009, Feb 23, 2013
    #2
  3. Feb 23, 2013 #3
    RiCeY

    RiCeY F O R U M W A R R I O R

    Messages:
    4,126
    Likes Received:
    447
    Trophy Points:
    83
    Joined:
    Mar 29, 2005
    Location:
    Australia
    Members Ride:
    VZ SV8 6spd 6.0 470rwhp
    Actuator will be stripped or jammed, the top one on the drivers side.
     
    RiCeY, Feb 23, 2013
    #3
  4. Feb 24, 2013 #4
    David egan

    David egan New Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Feb 16, 2013
    Location:
    Newcastle
    Members Ride:
    ve
    Thanks for bump and reply, I read in a similar thread someone stated to hold down the demise button for an extended period of time and it will reset the air on, did it and it works, hvac system shut down and when it came on everything was working fine
     
    David egan, Feb 24, 2013
    #4

Share This Page