Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

VE S2 Wagon boot trim removal

Discussion in 'VE Holden Commodore (2006 - 2013)' started by vewagon, Apr 26, 2013.

  1. vewagon

    vewagon New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Apr 26, 2013
    Location:
    warrnambool
    Members Ride:
    2012 VE Sv6 Sportwagon
    Hi all,

    New to the forum and was just wondering how to remove some boot trim from my SV6 S2 Sportwagon.
    Any help would be appreciated!
    See picture below of carpeted side panel in question. Cheers!

    Boot trim.jpg
     
  2. davey g-force

    davey g-force I'm a sceptic...

    Messages:
    3,060
    Likes Received:
    20
    Trophy Points:
    38
    Joined:
    Sep 5, 2005
    Location:
    "...the winner is..."
    Members Ride:
    02 RX7 S8 Spirit R 13B TT & 2013 Audi A3 1.8T DSG7
    If it's anything like the sedan, those hook thingy's should unscrew - grab them and turn anticlockwise.

    ...And if it's anything like the interior on any VE, the rest will unclip if you pull it hard enough! :D
     
  3. Bazztek

    Bazztek New Member

    Messages:
    12
    Likes Received:
    0
    Trophy Points:
    1
    Joined:
    Jan 11, 2014
    Location:
    Melbourne
    Members Ride:
    VE II MY12 Calais Sportswagon
    Yep those 2 screw things come out and then it pops straight out, I just did mine to change the globe in the boot until I realised there's like a little hatch door there so there's no need to remove the whole trim :yeah:
     
  4. Horacehighroller

    Horacehighroller New Member

    Messages:
    4
    Likes Received:
    1
    Trophy Points:
    3
    Joined:
    Oct 2, 2017
    Location:
    Black Rock, Melboure
    Members Ride:
    MY2010 International Wagon & VE11 Omega Sedan LPG
    There are also 2 Torx screws to be removed on the wagon, One is where the cargo blind clips in.
    The other is near the front beside the top of the rear seat uprights.
     
  5. VS_Pete

    VS_Pete Donating Member

    Messages:
    4,370
    Likes Received:
    7,794
    Trophy Points:
    113
    Joined:
    Dec 23, 2007
    Location:
    Brisbane
    Members Ride:
    VE II SV6 MY12 SPORTWAGON
    pics
     
  6. VE_WagonII

    VE_WagonII Member

    Messages:
    81
    Likes Received:
    16
    Trophy Points:
    8
    Joined:
    Oct 9, 2018
    Location:
    Melbourne
    Members Ride:
    VE Sportswagon
    To do it properly, remove the two tie downs on the cargo floor and remove the carpet strip. Unscrew the two plastic hooks on the side trim panel. Remove torx screw in area where cargo blind clips into when its pulled out. On the top on the plastic vent looking a fearea there's screws. Once removed pull towards you as it has clips. It will just come out over the silver bolt where the rear seat clicks into in the upright position. You need to wiggle it a bit from under the trim piece that runs up towards the roofline at the rear.
     
    Fu Manchu likes this.

Share This Page