Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Ve sv6 transmission service 5L40E

PORKSTER

New Member
Joined
Jul 22, 2010
Messages
16
Reaction score
2
Points
3
Location
adelaide
Members Ride
ve sv6
Can someone clear up for me the process to refill.... There's no drain hole.. So loosen bolts let fluid drain from pan.... Replace all... Take out fill plug and fill till drips out replace filler plug... But to check level have engine running remove filler plug?? Why doesn't all the oil come out at that point.. If engine running with filler plug open and you stop the engine it all comes out... But the engine was off when you took pan off replaced filter and pumped fluid back
 

Kingcarl

Active Member
Joined
Oct 28, 2017
Messages
179
Reaction score
48
Points
28
Location
Victoria
Members Ride
VE Sv6 series II MY 12.5
My advice,
Pay the bucks and get transmission specialist to flush and service.
There is a process and its not straight forward.
 

Dayvo

Because i can
Joined
Apr 28, 2005
Messages
2,669
Reaction score
8,466
Points
113
Age
67
Location
South East,Victoria
Members Ride
VE SV6 Series 2
Its a fiddly process. Car has to be on a level surface and trans fluid has to be at a certain temp. Trans has to be filled while engine is running till it runs out filler hole. Most transmissions don't have drain plugs so you have to drop the pan and change the filter. As Kingcarl said pay the buck to get it done.
 

lout

Well-Known Member
Joined
May 13, 2006
Messages
5,555
Reaction score
4,265
Points
113
Age
60
Location
Langwarrin Victoria
Members Ride
VXii Executive V6 , VYii Adventra LS1
loosen filler plug, do not remove, just in case you cant get it undone later
remove pan bolts leaving one corner
as you loosen that corner fluid will drain from opposite corner
may have to hit with palm of hand or rubber mallet if stuck
note which end of pan is front as the bolts are symetrical
change filter, clean inside pan and refit pan
then remove filler plug and fill with dex 6 to level plug
start car in engineering mode and go to trans temp
then with engine running fill to level plug
when trans temp hits 50 degrees with engine running refit fill plug
do not turn engine off until you have the fill plug back in
my daughters car had a receipt less than one month prior to purchase for trans service. when i did inspection i found it strange that all 3 rusty bolts under ac drain pipe had been refitted in same position, sure enough trans had not been touched
 

PORKSTER

New Member
Joined
Jul 22, 2010
Messages
16
Reaction score
2
Points
3
Location
adelaide
Members Ride
ve sv6
Cheer some great advice all went well... Especially the filler plug ****** was on tight quick go Friday night no joy... Got saturday
 

PORKSTER

New Member
Joined
Jul 22, 2010
Messages
16
Reaction score
2
Points
3
Location
adelaide
Members Ride
ve sv6
So big thank you to everyone who offered advice.... Ps I spent 2 weeks gathering info till I was sure I knew what I was doing and it was perfect
 
Top