VR engine loom and manual harness into VS

[maldotcom2]

Got it all wired up. Didn't use the manual harness at all, just cut off the VSS and wired it separately. Gus, when you removed the auto shifter plate there would have been a plug with 4 wires, 2 the same colour and one pink and one green. The two the same colour are your park neutral sensor so just short them together. The pink and green are the reverse lights, they need to be connected to the pins on the left side of the gearbox, doesn't matter what order they go in.

 

[Gus The Snail]

Cheers for that , i'll get it done on weekend , but....What about speedo???

 

[maldotcom2]

Speedo is operated by the vehicle speed sensor on the right of the gearbox. It has 3 wires, positive, negative and signal which goes to pin D2 on your ECU.