VR Indicators not working

[Muik]

I just bought a VR Series 2, and the indicators have just stopped working, Ive checked the fuses and made sure all relays etc are good, and they are, any one got any ideas as to what has happened?
Hazard lights dont work either.
Any help would be reat, thanks

 

[TheForgotten]

my first guess would be the hazzard switch. mine was dead when i got my VR too. when they go, they mess with the indicators.

 

[Muik]

Are the hazard switches interchangable from the vn to the vr? Ive got a vn im wrecking here so if i dont have to go buy parts all the better. Thanks

 

[TheForgotten]

99% sure they are, but I'm no expert

 

[Muik]

The missus is out in my VR so i cant check, and as I just got it i cant remember the location of the hazard in thr VR but i'm pretty sure there in different spots??
If this is the case would it mean they cant be changed over?

 

[DannyboyDS]

worst case scenario get a small length of wire 2 or so inches is enough and bridge two of the connections together.

From memory it will be the right most bottom and top ones, and from memory again I think they are brown, thats what I did when I broke my hazard switch, had to have indicators to get to the wreckers.

 

[jas98]

The missus is out in my VR so i cant check, and as I just got it i cant remember the location of the hazard in thr VR but i'm pretty sure there in different spots??
If this is the case would it mean they cant be changed over?

yeh there different switches

 

[st3r3otyp3]

These guys are on the money, It could also be as simple as the loom plug has somehow slid off the the switch buy previous dismatlment, oh and be careful not to break your facia when taking it apart.

 

[TheForgotten]

The missus is out in my VR so i cant check, and as I just got it i cant remember the location of the hazard in thr VR but i'm pretty sure there in different spots??
If this is the case would it mean they cant be changed over?

hmmmm yeah i should have known that. my bad

 

[Muik]

Thanks heaps for th help guys, it was the hazard switch, just gave it a good push in, and now the indicators are working. (unless the hazard switch is pushed in then nothing...guess that means im gonna have to replace it.)
Once again thanks guys:thumbsup: