VS Transmission Cooler Lines - How they fit in?

[nathanshnoz]

Hey guys,

One of my transmission cooler lines was busted to i removed the old ones and am now running new ones (well, ones i got from the wreckers).

Just wanting some pics or an explanation of how the lines run on the front/side of the engine. I know they go under the harmonic balancer, and then im not sure if they go over or under the oil filter? i know they hug the block afterwards but i've tried for like 3 hours to get them to fit back in and i think i'm doing it wrong.


Cheers,
Nathan

 

[Hugh Pearson]

Welcome to my worrrrrld Nathan. I'm trying to make my damn exhaust flange fit back but the transmission cooling lines seem to be in the way! (Engine change) I wasted hmmm 2 hours yesterday just fiddling with that flange thingy. I want to know where they go too... (can't remember how they went relative to the join of the exhaust pipe to the RH side manifold.) I see a bend in them suggesting they go on the block side, but still.... am out this morning to 'Pocket-a-Part' to find an old vs with engine and tranny in tact so I can 'seeee' how it works. I need a 3rd hand/arm most likely to shove them out of the way.

 

[heathgrimm]

Would you be able to tell me how the lines go at the front? Just did an engine change and think I have lines arse about face

 

[BlackVXGTS]

The attached diagrams may help you:

 

[Zingtech 82]

The attached diagrams may help you:

Hi could u upload this link/picture again? Having trouble downloading

 

[Immortality]

Nothing wrong with the link, works fine for me.

 

[Zingtech 82]

Nothing wrong with the link, works fine for me.

Damn it must be just my phone or something.
If someone can take a few pics of how the trans cooler lines run at the RH engine mount exhaust and bell housing I’d appreciate it.

 

[losh1971]

Does that help?

 

[Zingtech 82]

View attachment 206088

Does that help?

Yep a bit better, I’d love a pic though

 

[EYY]

The diagram is in the file above. Losh even posted a screenshot to help you. If you can’t figure it out from that it’s best you pay somebody to do it.

Hint: remove the drivers side header if you want to do it properly.