Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

vt 98 wont start need ideas

LazyGamer

New Member
Joined
Feb 7, 2013
Messages
27
Reaction score
0
Points
1
Location
Melbourne
Members Ride
vt commodore
Hey guys.
got myself a sv6 done some work to it.
second time i got this issue so far.

car stalled and wont restart. im getting fuel into the system but the engine wont turn over.
first time that it happened i was told to reset the ecu. worked the first time but now it wont work at all.


Any ideas what might be wrong with it?
 

billythakid

New Member
Joined
Feb 25, 2012
Messages
530
Reaction score
3
Points
0
Location
wello point
Members Ride
vx II Executive
Crank sensor , pour cold water behind the balancer and see if it fires
 

LazyGamer

New Member
Joined
Feb 7, 2013
Messages
27
Reaction score
0
Points
1
Location
Melbourne
Members Ride
vt commodore
if it was the crank angle sensor then the car would start when its cold.
 

lout

Well-Known Member
Joined
May 13, 2006
Messages
5,555
Reaction score
4,265
Points
113
Age
60
Location
Langwarrin Victoria
Members Ride
VXii Executive V6 , VYii Adventra LS1
do you mean it wont crank over or it cranks over but wont fire
stalling and then wont crank could be severely flat/faulty battery and faulty alternator or faulty ECU
you seem to have two unrelated faults or your description needs clarifying
 

getmo29

New Member
Joined
Mar 28, 2015
Messages
50
Reaction score
1
Points
0
Location
Sydney
Members Ride
VT Olympic Edition S2 3.8
First thing i would do is check error codes.

Crank angle sensors usually throw a code up if something wrong.

If you dont know how to check codes its very easy follows steps in this video.
https://www.youtube.com/watch?v=GyDlqnXv6NI

All you need is a paper clip or something similar
 

PRAVX II S

Member
Joined
Jan 21, 2010
Messages
918
Reaction score
7
Points
18
Location
Australia
Members Ride
Commodore
Hey guys.
got myself a sv6 done some work to it.
second time i got this issue so far.

car stalled and wont restart. im getting fuel into the system but the engine wont turn over.
first time that it happened i was told to reset the ecu. worked the first time but now it wont work at all.


Any ideas what might be wrong with it?

First off check for codes on the diagnostic connector located under the drivers side.
Also I read that you have checked for fuel but not spark you can have all the fuel in the world but she wont fire until you get spark and air in side of her.
 

billythakid

New Member
Joined
Feb 25, 2012
Messages
530
Reaction score
3
Points
0
Location
wello point
Members Ride
vx II Executive
if it was the crank angle sensor then the car would start when its cold.
You didn't mention if hot or cold , by your description it stalled and wouldn't start .
Is it just a dead key when turning ignition or does it crank but won't fire ?
 

LazyGamer

New Member
Joined
Feb 7, 2013
Messages
27
Reaction score
0
Points
1
Location
Melbourne
Members Ride
vt commodore
my fault with the lack of information.

cranks but wont fire up.
cold start too.

battery is about 6 months old.
had the crank sensor replaced already.
 

billythakid

New Member
Joined
Feb 25, 2012
Messages
530
Reaction score
3
Points
0
Location
wello point
Members Ride
vx II Executive
Take the 2 plug leads off each coil pack ( 1 pack at a time ) quick crank and see if it sparks between the poles on each coil pack , if none spark then DFI module under them is most likely the issue
 

lout

Well-Known Member
Joined
May 13, 2006
Messages
5,555
Reaction score
4,265
Points
113
Age
60
Location
Langwarrin Victoria
Members Ride
VXii Executive V6 , VYii Adventra LS1
pull a spark plug and see if you have spark
can you hear the fuel pump prime for 5 seconds when you switch ignition to reds
 
Top