Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

vt stalling at running temp

Discussion in 'VT - VX Holden Commodore (1997 - 2002)' started by vtseries2, Dec 27, 2011.

  1. vtseries2

    vtseries2 New Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Dec 27, 2011
    Location:
    new zealand
    Members Ride:
    '99 vt s2 3.8 v6
    hey ive been looking everywhere online and cant find anything that helps the car has a knock but only when on running temp. and then when it goes to idle it just stalls i can see a bit of oil loss as well the knock is coming from the inlet manifold or the rockers but the lifters has been check and tested just had a service and waterpump and thermostat replaced.
    PLEASE HELP
     
  2. ucwepn

    ucwepn America just kicked in yo

    Messages:
    2,472
    Likes Received:
    16
    Trophy Points:
    38
    Joined:
    May 19, 2005
    Location:
    Melbourne
    Members Ride:
    WH statesman 5.7
    how long does it run before stalling? does it restart easily again after stalling? do the fans come on at all?
     
  3. Wombles

    Wombles Cars cost too much.

    Messages:
    2,078
    Likes Received:
    8
    Trophy Points:
    38
    Joined:
    Oct 28, 2009
    Location:
    Gippsland
    Members Ride:
    '72 LJ Torana, '95 VS Acclaim and V8 wagon
    Checked the error codes?
    Could be CAS.
     
  4. vtseries2

    vtseries2 New Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Dec 27, 2011
    Location:
    new zealand
    Members Ride:
    '99 vt s2 3.8 v6
    it wont start up again until its cooled down if i drive it takes about 10 km or idle for about 30min then cuts out the fans come on and goes off like normal
     
  5. vtseries2

    vtseries2 New Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Dec 27, 2011
    Location:
    new zealand
    Members Ride:
    '99 vt s2 3.8 v6
    it does not throw any codes or engine lights out at all would the knocking be caused by a faulty CAS
     

Share This Page