Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Vxnot cranking after manual conversion

Discussion in 'V6 Development And Modification' started by Vx love haha, Jun 28, 2019.

  1. Vx love haha

    Vx love haha New Member

    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Joined:
    Jun 27, 2019
    Location:
    Grafton Nsw Australia
    Members Ride:
    2001 vx spac
    I need help I’ve done a manual conversion from a vt I tried to use the manual loom and i could not get it to link with the bcm, so now I have a auto loom in and I do not know how to bypass the neutral safety switch I literally have look up the question everywhere and have found nothing helpful I’ve asked auto sparkys in the area and they haven’t been much help either, I did try using the selector thing from the side of the old auto gearbox and putting it in park position and still nothing I’ve replaced the starter and most fuses so I don’t think it’s that either I’m not sure what else there is to try?
     

Share This Page