Normally stock pads on normal use will get you 150,000.
5. SPECIFICATIONS
BRAKE FLUID
Type ......................................................................... Super DOT 4 Plus
BRAKE BOOSTER
Make ......................................................................... PBR
Type ......................................................................... Tandem, Vacuum Suspended
MASTER CYLINDER
Make ......................................................................... PBR
Type ......................................................................... Tandem
Bore diameter (nominal)............................................. 25.4 mm
Crack point ................................................................. 3.1 MPa (stamped on master cylinder end plug)
FRONT DISC
Type ......................................................................... Ventilated
Diameter (nominal)..................................................... 296 + 0.0 - 0.2 mm
Thickness ................................................................ 28.0 ± 0.15 mm
Lateral Runout (maximum) ..................................... 0.04 mm Total Indicated Run-out (TIR)
Minimum disc thickness, requiring replacement ........ 25.0 mm
FRONT CALIPER
Make ......................................................................... PBR
Type ......................................................................... Twin piston, sliding caliper
Bore diameter (nominal)............................................. 42.0 mm (each)
Front Disc Pad
Material.................................................................... Organic, non-asbestos
Minimum Thickness before Replacement............... 2 mm
REAR DISC
Type ......................................................................... Solid
Diameter (nominal)..................................................... 286 + 0.0 - 0.2 mm
Thickness ................................................................... 15.9 mm ± 0.2 mm
Lateral Runout (maximum)
(Rate of change 0.03 mm in 30O rotation max.) ...... 0.05 mm
Minimum disc thickness, requiring replacement ........ 13.9 mm
REAR CALIPER
Make ......................................................................... PBR
Type ......................................................................... Single piston, sliding caliper
Bore diameter (nominal)............................................. 40.5 mm
Rear Disc Pad
Material.................................................................... Organic, non-asbestos
Minimum Thickness before Replacement............... 2 mm
DRUM PARK BRAKE
Make ......................................................................... PBR
Type ......................................................................... Banksia, single shoe, cable and lever operated
Drum
Inside Diameter (nominal)....................................... 190 mm
Maximum out of square (TIR with disc surface) ..... 0.05 mm
Maximum out of round ............................................ 0.08 mm
Linings
Type ........................................................................ Bonded
Width ....................................................................... 25 mm
Thickness ................................................................ 3.5 mm
Minimum Thickness before Replacement............... 1.5 mm