Vy v6 3.8 turbo info

[Vyute78]

Stage 2 from Tony’z garage
Doing it properly
280-300rwkw

 

[Vyute78]

I did drive a ba xr6t ute
And a 2.2 ts Astra which was built for Supercharger

 

[TheIceman]

yep, power upgrade aint cheap. normally around $10 mark. then more after you start blowing other things up.

 

[shane_3800]

I wouldn't run high ratio rockers. With cam and boost you'll need stronger springs. I would be hesitant on using a cam tbh. If you decide to use a upgraded cam make sure you upgrade the springs and look into a dual row timing chain. If you use a dual row you have to delete the balance shaft if you do this you should run a race balancer.
It's much easier using a standard cam and rockers then just feed her boost.

 

[_R_J_K_]

$10k to turbo Ecotec V6. ?? Wtf were you thinking ?? Lol. OMG.

$10k for total build, not just for putting a turbo on it.

 

[Utel67]

Much cheaper than putting typhoon badges on a XR6 turbo lol OMG

 

[turbovich]

Much cheaper than putting typhoon badges on a XR6 turbo lol OMG

Who put typhoon badges on a XR6T ?

 

[turbovich]

Glad you cleared that up ! OMG lol etc......

 

[Vyute78]

Ok so turbo on
Chinese g3582 with billet wheel
Valve springs
Cosmetic head gasket
Sealed all around
Rising rate fuel reg
Didn’t put the rockets on
750cc injectors
Etc etc

so who tunes the factory ecu
Other than Damien at greham West Marion in Adelaide

 

[Utel67]

Ford rebadged a xr6t and charged there dumbass costumers thousands more for typhoon badges lol OMG (FORD) found on rubbish dump.