Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

VZ 05 wont cank over...ecu, bcm, sensors? PLZ HELP

Discussion in 'VZ Holden Commodore (2004 - 2006)' started by mx_chik, Jan 16, 2011.

  1. mx_chik

    mx_chik New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Jan 16, 2011
    Location:
    brisbane
    Members Ride:
    253 hilux
    Hey guys i have read through other threads on here to try sorting out my issue but each one is a little different to my situation so thought id list the specifics.

    Its an 05 VZ as stated (auto), last night we went to go out for dinner and it wouldnt start. Just ticking at the stater motor no cranking. It was first claiming an ABS fault, then later, low fuel, service and SRS airbags. i have checked terminals, battery, starter wires and reset the ecu. since reseting, the ignition wont even turn on so i cant even system check to get an error. Has anyone experienced this before please help!!
     
  2. impulsive

    impulsive Alloytec Racing

    Messages:
    1,872
    Likes Received:
    17
    Trophy Points:
    0
    Joined:
    Aug 29, 2007
    Location:
    Brisbane, QLD
    Members Ride:
    VZ Alloytec
    Dead battery... Replace it you should be fine. Ticking at the starter motors usually tells me this
     
  3. richardpalinkas

    richardpalinkas Blown Alloytec

    Messages:
    2,290
    Likes Received:
    11
    Trophy Points:
    38
    Joined:
    May 4, 2009
    Location:
    Gold Coast
    Members Ride:
    Raptor Impulse VZ SV6
    all the faults appearing also tells a dead battery. my battery went and said abs fault a week before it died
     
  4. db_notso

    db_notso diagnostic technician...

    Messages:
    979
    Likes Received:
    6
    Trophy Points:
    0
    Joined:
    Oct 2, 2010
    Location:
    sunshine coast, qld
    Members Ride:
    vt v6, mods(susp brakesetc...)
    +1 dead battery
    the abs module doesnt have enough voltage to wake up and so sets codes in ipc "abs fault"
    light goes out if jump start if battery fault as altenator takes over the supply job of voltage

    else worst case scenario intermittant no clicking and no start is earth inside ECM needing new engine control module
    replace battery check if any lights on then repost here!~
     
  5. impulsive

    impulsive Alloytec Racing

    Messages:
    1,872
    Likes Received:
    17
    Trophy Points:
    0
    Joined:
    Aug 29, 2007
    Location:
    Brisbane, QLD
    Members Ride:
    VZ Alloytec
    I can get batteries for $40
     
  6. Chrain01

    Chrain01 New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Joined:
    Nov 21, 2016
    Members Ride:
    VZ Commodore V6
    Had same issues, had new battery as old one was stuffed but all faults came after new battery was installed, just came from Holden and after two days they found the ipc not communicating correctly and throwing the same codes abs srs low fuel etc .. might help someone with similar faults
     

Share This Page