what did you do to your car today?

[ari666]

i did this:

 

[ari666]

$56 later I got the right tools to tackle the job

14cfm compressor
1.4 spray gun
watertrap
air hose
sundstrom particle mask
250mls 2k hi fill and hardner
250mls 2k white plus hardner
250mls 2k thinner reducer
red scothbrite
2" masking tape
newspaper
clean rags
prepsol


all for 56 bucks??? nice work!

 

[turmoil117]

14cfm compressor
1.4 spray gun
watertrap
air hose
sundstrom particle mask
250mls 2k hi fill and hardner
250mls 2k white plus hardner
250mls 2k thinner reducer
red scothbrite
2" masking tape
newspaper
clean rags
prepsol


all for 56 bucks??? nice work!

Nevermind ... Im an idiot

 

[pjdm1980]

i did this:

pjdm1980

 

[Drawnnite]

still looking at things to do to it.
and contemplating if to do it or not.

also looking at another one as usual.

oh and it got cleaned yesterday.
rims look so awkward back to normal grey/silver instead of 2 months of dust.
looks very clean after that run in the wombat state though, was that dirty the paint actually looked brown

 

[UNLEASHED]

Just get someone to push down on it when your pulling on the latch.



PJDM1980

Or if you hit the top rh corner while pulling the latch this sometimes works aswell.



- As for me;

Sold my boat.

Yup, Tried that. May have been when I "Starsky&Hutch"ed across the bonnet...OK, it was more like a suplex, to try open the bonnet in the first place. She's down hard on the bonnet lacing against the headlights and grille. Used the clublock to push the bonnet release lever up, AND grabbed the cable aswell. Even used a screw driver(shock horror, I know) between the guard and the bonnet.(if you saw the bodywork it wouldn't make you cringe so much)

 

[Wombles]

Gave it too much revs around a corner in the wet.

 

[kingswood country]

Fluffy sounds lumpy, I like it


Sent from your god, for you to worship and give money

 

[kingswood country]

I enjoyed my morning commute


Sent from your god, for you to worship and give money

 

[UNLEASHED]

Yup, Tried that. May have been when I "Starsky&Hutch"ed across the bonnet...OK, it was more like a suplex, to try open the bonnet in the first place. She's down hard on the bonnet lacing against the headlights and grille. Used the clublock to push the bonnet release lever up, AND grabbed the cable aswell. Even used a screw driver(shock horror, I know) between the guard and the bonnet.(if you saw the bodywork it wouldn't make you cringe so much)

Got the bonnet open after 1 1/2hours- Biiiig screw driver up under the bumber and undid the spring bonnet release. Found the cable 1/2 buggered and the bonnet misaligned. Going to take the inlet manifold off and silastic the hell out of it to stop the possible airleaks- Hopefully she fire the way she used to.....
Looking at ebay for a new bonnet release cable( plus gaskets and more. Give it a good enough wheel alignment to get her down to the tyre mob to get it done properly...