Need a 650 double pumper square bore carby. Don't care if the choke housing/air horn has been milled off or not. Will be happy to get one that suits rebuild. Will probably have a list number of 4777 for those who have a holley floating around in the garage and unsure what size it is. In melbourne and will either pickup or pay for postage/freight. Cheers, Troy
hey i have a holley DP 4 barrel i want to sell but will go to my mechanics tommorrow to find out if its the 650 or the 450. im thinking around the $200 mark for it. u?
That was quick Let me know tomorrow which one it is and I will be happy to discuss further with you. If it's the 450 it's way too small for me, even the 650 is pushing it but it's just for running in at this stage and thats why I'm after the 650 plus I will use the 650 later on a smaller motor. Cheers mate, Troy
ok will do troy. get back to u by tommorrow with details. what car u putting it in and what cube engine? Do u need any other goodies?
Will be going on a 396 big block chev for run in then moved over to a 400+hp 305 small block. I'm always looking for bit's and pieces but never quite know what I need till I get to that part of the project. If you have a list of bit's you have, then I'm happy to look it over. Either of these motors will end up in the HT wagon, just have not decided which one yet. To save further questions on the wagon, it is a: Plain white 1970 HT wagon 2 speed powerglide, race preped, 3800 stall 9" diff 4.11 ratio full spool HQ disk brakes front Will end up with either of the engine combinations above. Cheers mate Troy
its a 450 holley double pumper 4 barrel square bore etc etc. needs a float in one of the pumps replaced. will sell for $50. Had it running in my HK PREM 69 with chev 327 modded in it and it did well till i took it out and replaced it with a new chrome finish holley 750DP!
