Recent content by Just Damo

All good with them, they’re removed and the new ones in, just wondering what these 2 O’rings are for from the pack

So where I have removed the rubber from. That tin look ring should be removed with the seal hey?

The coil seals in the rocker are pricks to get out aren't they, just crumble when I get at them with the pick tool

I got the Haynes bible there but doesn’t say anything about patterns, I’ll download that on the pc shortly. Might go invest in a little pick tool on my adventures today. Cheers for that mate

Cheers Fu! Will be getting back to it since I’m back home from working away. Is there a sequence for the rockers as well? Also, I’m having trouble taking the coil seals out of the rockers, is there an easy solution to removing these?

Is there a sequence to tightening the rocker cover bolts? And at what nm? Or is it a case of do it up to just over hand tight? Cause they were easy to undo

Can you remove the fuel line without the tool or should II just wait to get one tomorrow?

yea sweet, cheers for that. Was worried I would spill some down into the motor if I tried. Drilled out the PCV a while ago as per your thread on it. You can definitely hear the system sucking haha

Got all that good gear from Revhigh a little back. Just seen some that put the goop where they have it in the pictures, but some that don't do it. Just wanna see others opinions so don't risk it leakiing

Is the drivers side the side that is normally more gunked up than the other?

As for when putting in the new gaskets for the rockers, after cleaning up the contact areas, am I to put some of the blue gasket maker in the corners where they have applied it in the factory? (pictures should show the old stuff)

Got the driiverrs siide Rocker cover off, everything is looking nice and clean enough, please tell me otherwise if I am seeing things. Gotta grab a fuel line tool to get the inlet off to get to the other cover with ease. And didn't have to do much with the gas gear, only disconnected the lines...

Thanks mate, appreciate it!

Get to also find out if the motors been maintained well prior to my ownership

will do, cheers for that. No way to remove the parts needed with them in the way