Search results

Sorry to necro an old post, but where in the Sam hell is this module on a WK I'm having the exact same issue!

wizard, im assuming centre console trim needs to come off to access those bottom screws lol

Yea I'd like that mate thank you

As the title states, I'm wanting to remove the screen to change the smd Leds, before I just go blindly taking things apart, anyone got a walk through, pictured below is what I'm removing

Has anyone got the pinout for vy clusters? Mainly just need 12v ground and illumination, on vzs it's 1 19 and 17, but vy it isn't, any help would be greatly appreciated

Hey mate, I just put the WL Tails into my WK and it was a straight swap, no different plugs, nothing :)

ALCMCQ thank you SO much for hijacking my post! really, keep it going! As to the fins, they are fine, all been checked out, Im swapping the radiator for a really good one and seeing what happens

The temperature is what I said before, it says it on the dash and confirmed by heat gun, havent done a compression test yet, but the radiators I have put in there, Ive just realised, are only 26mm thick, tiny little things, factory is around 50mm by memory, so im going to put a oversized...

Bump

Hi guys n gals! Three (yes effin three) years ago now, my radiator dumped all of its coolant and I coasted home about 400m, the temperature gauge never went over half, the car didnt overheat, all was ok, I replaced the radiator and the thermostat and was on my merry way, after this incident...

Filled up my gas tank today and the needle is staying on flat empty with the fuel light on, I switch it to petrol and it starts to climb... What could be the problem?

Ill be doing the 2 ohms and im getting another car obviously haha

Well, the 18's are 3000 RMS each.. So Yea this isnt that much compared to that

Thanks so much for the help :P now what car to put them in :) lol

I want a full kicker system... If I waited like 2 monthes I could get 6 18" Solo X subs with 2 Kicker warhorse amps, But that might be a bit much

So I should be right with the 2500 rms on the 2 15" L7's?

I didnt say they have a 2000 RMS amp, I said they have a 2500 RMS amp

It is recommended on the Kicker Website that the Dual L7 Sub-woofers should be powered by a Kicker ZX2500.1 Amplifier... Here's what I do not understand as I'm new to the "technical terms" Of car audio L7 15" Sub-woofer is Rated at 2000/1000 Peak/RMS respectively the ZX2500.1 is a Class D...

Not entirely in the boot, the Amps are under the rear seat, the subs are in a custom fibreglass box

Lol its an 18" 3000 rms incredibly awesome subwoofer, go to youtube and type fi btl

I had 2 12" kicker comps that hit pretty hard, but then I came into some money So now I have 2x N318 DUAL 1 | DUAL 2 Fs: 51.1 Hz | 50.4 Hz Re: 0.7 Ohms/coil | 1.4 Ohms/coil Qms: 10.1 | 10.26 Qes: .36 | .35 Qts: .35 | .34 Mms: 320g | 329g Sd: 1210cm^2 | 1210cm^2 Vas: 62.1 l | 62.1 l Spl...

I aint mounting a box on the shelf, Im mounting it on the floor of the boot

still need my question answered though lol

My bad, I'm on my phone must of mis clicked

I've been hearing a lot if rumours going around that its actually illegal to have a subwoofer in a car that has a gas tank is this true?i don't want to damage my car with this system

Solved the amp problem, Im mounting it on the wall just under the boot latch, Second question, Does anyone know the exactly dimensions of where the fuel tank starts and finishes on all sides?

Not being mean, But you obviously have no idea what you are talking about, the gas tank takes up the entire parcel shelf, there is no room above or behind it, Like all gas tanks into a VS

Hey, Having a gas tank means there is no room between the tank and the seats, So I have to mount on the floor of the boot

Im looking to install a 12" Dual kicker comp sub in my Acclaim, But I have a gas tank on the shelf, So I was wondering if there was anyone here who know precisely where the petrol tank starts and ends when looking from inside the boot so I dont puncture through when I mount the subs...