fault code

Hey, just after some advice. I’m having fault 31 coming up on ‘96 VS Ute, turns over but won’t start. As far as I understand it’s the BCM not sending a signal. I also think the key might be broken. My question is, will either of these 2 fixes work? 1) replace BCM + key fob Or 2) get a new key...

Hey all can’t seem to find a way to check for fault codes on an LS1. It’s a 2002 VX Calais. I bridged pins 5 and 6 but looks like that only works for the V6 and 304 engines. Do I bridge different pins or that method is out of the question for the VX LS1s. Cheers

Hi I have changed 2 ecu's on my 2011 ve the car would drive until it got hot and cut out with all instruments going haywire and engine warning light flickering. I changed the ecu and it ran fine for few months until it did the same thing so I have changed it again and now the fault code P0158...

Hey guys I’m stuck my 2004 VZ comes up with a powertrain fault so I go to Neighbor code stated oil pressure sensor, I replaced it then go for 5kms drive come up again. Car drove back in limp mode. Turned car off then started straight away and it ran sweet. It’s done this a couple of times in one...

Hey guys I am looking at clearing an airbag light on my VS Commodore Obviously as the older commodores still run the the OBD1 as opposed to the OBD2 would I need a OBD1 compatible machine to clear the codes I have tried to on my current scan tool but it appears to be greyed out and I am...

Hey getting fault code p0502, replaced rear harness and wheel sensors anything else I should check? Replaced battery as well.

Hi everyone, Trying to decide what exhaust to go with for a 2008 VE SSV. My first preference would be a full engine back system with headers, high flow cats and cat back, however my main concern is whether this will cause fault codes to appear. I've tried asking several exhaust shops and I...

I have a 2003 VY SS ute. The "Check Engine" warning comes on sometimes. The car seems to drive fine and has done for a week. Does this just mean the warning parameter is JUST tripping? Thankyou

Hello Guys I have a series 2 VS wagon ecotec Lately after I have been driving for about a minute my engine light comes on and stays on (solid). Occasionally it is ok and stays off. If I turn off the engine and short out pins 5 and 6 the code 12 comes up. I have looked in my Ellery manual and...