jafo
lurker since 2003
- Joined
- Oct 7, 2003
- Messages
- 737
- Reaction score
- 6
- Points
- 18
- Age
- 59
- Location
- adelaide
- Members Ride
- 1999 wh statesman
instructions on adding C.A.I on VS V6.
parts required to do job as follows
Inlet assembly
#: GM-92053315
Duct to air box
#: GM-92053314
Bottom assembly of air box
#: GM-92053006
drill
screwdriver (rivet gun if using rivets)
and new air filter if needed
parts required to do job as follows
Inlet assembly
#: GM-92053315
Duct to air box
#: GM-92053314
Bottom assembly of air box
#: GM-92053006
drill
screwdriver (rivet gun if using rivets)
and new air filter if needed
- open bonnet
- undo clips on airbox and lift up
- remove air filter
- remove 3 screws in bottom section of airbox (if replacing this section)
- lift out bottom half of airbox and put aside
- take new section and clip in the ducting to side of new box (just pushes in)
- place new section where old one was and replace the screws
- place the inlet over the top of radiator and connect the ducting to make sure you have a good fit
- make marks where you have to drill the holes in the radiator shroud with pencil or similar.
- remove inlet
- use drill to drill holes in shroud (remember not to drill no more than 1/2 inch through shroud)
- place inlet back on ducting
- and screw or rivet inlet to shroud
- replace air filter
- place the top half of box back on bottom half of box
- do up clips
- start engine and check all is fine (IE: no leaks around box)