aza03
New Member
- Joined
- Dec 2, 2005
- Messages
- 60
- Reaction score
- 1
- Points
- 0
- Age
- 36
- Members Ride
- ve series 2 ss
hi this has most likely been done before but i took some photo when i was fitting my towbar so i may as well share them. sorry about photos they are off my iphone the camera is so sh!t.
STEP 1: remove rear bumper
View attachment 88482
three Phillips head screws
four phillips head screws in the plastic so you can fold back carpet
four clips in bumper
two 10mm nut on each side under each tail light
STEP 2: remove support bar and brackets
remove the 4 bolts i think they are 17mm from memory
remove 19mm nuts to remove brackets
STEP 3: fit towbar
fit towbar and put nuts back on
STEP 4: install wiring loom and replace bumper bar
wiring loom plugs in on driver side under tail light, then you can put the rear bumper bar on and put the carpet back in the boot. hope this is a help to someone.
STEP 1: remove rear bumper
View attachment 88482
three Phillips head screws
four phillips head screws in the plastic so you can fold back carpet
four clips in bumper
two 10mm nut on each side under each tail light
STEP 2: remove support bar and brackets
remove the 4 bolts i think they are 17mm from memory
remove 19mm nuts to remove brackets
STEP 3: fit towbar
fit towbar and put nuts back on
STEP 4: install wiring loom and replace bumper bar
wiring loom plugs in on driver side under tail light, then you can put the rear bumper bar on and put the carpet back in the boot. hope this is a help to someone.