MEESEN
"SOON"
How to Install Front Power Window Regulators into a VY
Ok, This isnt covered in the "How to install Power Windows" thread so ill quickly cover it for anyone interested...
What You'll need:
What You'll need to do:
and your done!
Ok, This isnt covered in the "How to install Power Windows" thread so ill quickly cover it for anyone interested...
What You'll need:
- 2 People
- 10mm spanner or socket
- Rivet Gun
- Pop Rivets (to fit holes)
- 4mm Drill Peice
- Drill
- Door looms with Power Window Connecter
- T15 torx driver
What You'll need to do:
- Remove your door trim & Remove the plastic
- Remove Speaker and Side mirror (done buy supporting mirror and removing 3 T15 Screws then disconnecting the wiring)
- Remove original wiring and replace with door looms that have a power window connection
- Re attach side mirror
- Wind the window down 1/4 of the way (so its 3/4 up) and have your assistant hold the glass supporting its weight
- Remove the two 10mm bolts on the slide rail
- Drill out 4 pop rivets (your assistant now has the whole weight of the glass)
- Remember how the regulator is attached to the glass and then maneuver the regulator until you can get it out
- Slide in new electric regulator and attach to glass rails
- Line up the regulator support bracket with the 4 holes you previously drilled out and rivet into place (Your assistant may need to raise or lower the glass a tad)
- Re-fit the slide rail with the two 10mm
- Connect Door loom to the new regulator
- Check to make sure it moves up and down freely
- Replace Plastic & Door Trim
and your done!