Mate's ED turbo Sleeper

[Pub247]

hey ari it does look that way. It may be becuase its hanging at full droop in there picture. When the car is at static ride height it sits square and even.. I will not that i still need to make new bushes for the lower control arms as they are indifferent spots due to it be x series axle tubes instead of e series

 

[Pub247]

Alomst done only thing left really is the anti roll bar wasnt going to work where we first intended nor the 2nd position so we thought of a 3rd position but it'll have tp be done on the hoist. Also require removing the wheel well.

 

[AirStrike]

Going for 7's? That's a fair wing!

 

[skappascrap]

Holy updates, Batman!
Loving the updates

 

[Pub247]

Going for 7's? That's a fair wing!

Thanks made it myself turned out pretty good theres a couple thigns id change for next but once its powdercoated black it'll be better.

We figure since it's not a sleeper anymore and now a drag car we might aswell go all out and make it a drag car.

I think 7's is not on the cards yet a low 9 then clean up some issues we have then an 8 would be nice once its turned up to 30psi

 

[dingeldei]

nothing says sleeper like a parachute haha.

 

[Pub247]

Went back on dyno todayjust to check a few things and setup new boost controller. We added a little more boost (4psi) but not seeing great returns in regards to power and its making intake temp a bit higher. Thinking it time for a gtx wheel or possibly bigger turbo. Beast though torched the 275 radials on dyno blew rubber chunks everywhere. had to go full vl spec and have people sitting in boot

 

[Pub247]

 

[AirStrike]

Video is private, can't watch it.

 

[Pub247]

Work now????