The Mace upgrade on the ute

[MACE]

Two people would definitely make this job much easier LOL

 

[sp001in]

mine managed to fit with no probs 4-5mm clearance. have the same spacer set up as you do. just took abit to get it lined up right and need two people to make it easy

Do you have the genuine HSV strut brace or a pedders one?

 

[STL17]

Did u have to retune after you fitted tb

 

[sp001in]

I didn't have to, it ran great straight away.

BUT I sent the computer off on Monday to have it retuned by memcals.com.

Dr.BOB has doen a nice little performance tune on it which will increase response and power and better fuel economy. total cost $332 including express post each way.

 

[sp001in]

Computer back today. HOLY ####.

100k's is coming up faster than it did with the supercharger.

 

[2DIE]

Computer back today. HOLY ####.

100k's is coming up faster than it did with the supercharger.

Damn...

Do you have a 0-100 time?

 

[sp001in]

I'll time it when I get on the highway tomorrow. Had a quick go today in the 90zone, put the foot down at 60 and needless to say it went past 90 very quickly.

 

[vxcalais_01]

Do you think you may have used too much sealant ? That groove in the lim is for the oil to run into. Dont block it. I am sure i have seen a strut brace that goes behind. Check Whiteline or superpro

 

[SuperSixty6]

Are you sure the site is 'Memcals.com' , I am getting warning messages before entering the site. Don't want to take any risks as i am not on my own Computer. One that note, How much does it cost to get the VY computer tuned?

 

[sp001in]

Do you think you may have used too much sealant ? That groove in the lim is for the oil to run into. Dont block it. I am sure i have seen a strut brace that goes behind. Check Whiteline or superpro

I cleaned it all up, and the chanel is not blocked. will check out those sites and see.

yes site is memcals.com 100% positive on that.

cost $300 + postage. took 2days.