VS Uterus

[PirateJoe]

Can you get a hacksaw blade in there? Cut a slot in it and use an impact screw give it a good smack so it cracks then wind it out with some vise grips and buy a new set of bolts.
Or try a little heat with an oxy pen if you havent stripped it out.

 

[Leathal11]

yeah i ended up getting a second set of rails just incase i stuffed something haha think they cost me $12 for two sets, and yeah if you can get in there you could try V8VKJoe's idea or mabe even try get some vice grips nice and tight on them. hopefully you can get them out alright and if ya do get them out dont put them back in get some new ones or if you can replace them with new ones or some decent second hand ones

 

[tim005]

thanks for the replies fellas.
i tried the hacksaw thing, i couldn't bend the rails far enough to get the blade in without doing damage.
i'm going to hit up the wreckers tomorrow, saves effort and breakage.
i'll let you guys know.

 

[Leathal11]

if ya where in adelaide man id try give ya a hand haha but good luck, let me know if there is anything else i can help ya with

 

[tim005]

I went and bought rails man. Beyond me on how you got them for 12 bucks haha.
I called 6 wreckers and the most expensive for a pair was $150, i ended up buying them for $80.
Oh well, what can I do.
I'll let you know how install number two comes along.

 

[Leathal11]

wow that is expencive! i got them from U pull it which is a wreckers where you take the part out yourself

haha yeah keep us posted mate

 

[Leathal11]

small little update! went and picked up a little present for the ute today

 

[Leigh_G]

Ahh nooooiiice! What'd u get it out of? And has that got the std pulley or is it the smaller/higher-boost one? Sry not that well versed in the super6's. Should haul ass when it's all hooked up though!
+1 for Maccas too, I remember the late nights swapping my VN motor, the big M becomes ur best friend.. Mmmmmm McTransfluid :smoking:

 

[Trayner]

l67 and a bald tire ... nice ! hahha should make the ute boogie a bit more

 

[Leathal11]

completely stock for now and its out of a VT calais, yeah should give it a little bit of go now.


ok just a couple more photos as we have just pulled it out the back of the ute today

now to clean it up make sure everything is right, then start the install which will hopefully be in 2weeks