VY ute, super lows on rear only

[calobes]

Hey everyone,

Want to lower my VY SS ute, not dump it on its ass, just level it out a bit as the rear sits up high.

It's got stock alloy wheels (which I will change in the future, probably to 19s or 20s) and Tri y extractors to high flow cats being the lowest point under the vehicle.

I keep about 50-60kg of tools in the tray all the time plus a hardcover that I think is probably about 25-30kg so it still needs to be practical.

Anyone got one with super lows in the rear only? Any advice would be appreciated.

Anyone with pics of this setup would be awesome.

Cheers

 

[lowandslow]

Here's a picture of my old ute with Kings SL HD springs under the arse of it. Front springs are Kings Lows.

 

[calobes]

Here's a picture of my old ute with Kings SL HD springs under the arse of it. Front springs are Kings Lows.

That's pretty much what I'm after. So lows on the front and super lows on the back. Get any scraping over speed bumps etc?

 

[Bowen]

That's what I had on my vx s and it was Awsome only the occasional scrape when there was a sharp and sudden change in the ground

 

[calobes]

That's what I had on my vx s and it was Awsome only the occasional scrape when there was a sharp and sudden change in the ground

So all good over most speed bumps? Heaps around where I live at the beach.

 

[lowandslow]

Yeah wasn't too bad. I was running Twin 3" pipes so it did hang a bit low but it was practical enough for everyday driving. Hell it was like this for nearly 8 years.

 

[Bowen]

So all good over most speed bumps? Heaps around where I live at the beach.

So long as u slow down for them yeah all good it was just like steep driveways which go from flat to steep etc

 

[calobes]

Thanks for the help guys, lows on the front and super lows on the back it is.