All
Freshening up a C4B from previous owners. I may have a problem where the cam was changed and they used the incorrect length pushrod. The reason I suspect this is all the pushrods are worn where they go through the head to the roller rocker.
Assuming the worst, if I was to replace the roller rockers, what would I replace them with? I am just looking at putting it back to where it was ( or perhaps a little more).
It is running a cam that is stamped "SRE 35192". Tried finding the specs on this but have not been able to.
I have also noticed that the tops of some of the valves seen to e a little worn.
Any and all suggestions happily accepted.
Freshening up a C4B from previous owners. I may have a problem where the cam was changed and they used the incorrect length pushrod. The reason I suspect this is all the pushrods are worn where they go through the head to the roller rocker.
Assuming the worst, if I was to replace the roller rockers, what would I replace them with? I am just looking at putting it back to where it was ( or perhaps a little more).
It is running a cam that is stamped "SRE 35192". Tried finding the specs on this but have not been able to.
I have also noticed that the tops of some of the valves seen to e a little worn.
Any and all suggestions happily accepted.