ignition module connection plug loose

[lwessel]

You should be able to fasten it adequately using a cable tie. Did this for my wife's VS Clubsport and has been fine for the last 15 years.

Oops, just noticed your ride is a VE, in which case you have posted in the wrong forum, and the advice above may not be correct.

If you are posting on behalf of someone else with a VN-VT1, then the advice is correct.

Hey its a VR 5lit but will try you advice

 

[lwessel]

I think the OP has acquired a VR or VS V8 and it's his project car, just not listed in members ride.

How do i list it?

 

[Tonner Matt]

How do i list it?

Click on your username near top right of the page when logged in
This will bring up your "Personal Details" page
Scroll down and you will see a box "Members Ride".....Yours will currently say "VE SS V8 Commodore"
Add or remove vehicle details as necessary in that box
Click on "Save Changes" at bottom of the page and you're done

 

[wildfiremaint]

This ?

 

[lwessel]

how is the plug loose?..is it the whole plug or is it just the metal connectors and pins?
if its the whole plug wrap some duct tape with a decent folded tab around the plug and socket and use dabs of hot glue...if you need to remove it use the tab on the duct tape to brake the seal of the hot glue...if it connectors and pins then use an o-ring pick to very very gently close em up a bit....

You were right, female connector to pins loose as