Memcals: Knock sensors and limp home resistor packs

[hakhawk]

http://www.cruzers.com/~ludis/1227165schematic.html

then click connectors. look down the bottom left of the image and u will see the outline of the memcal socket. CAL53 is pin 53, GND

 

[TO4355]

ahhhh thanks heaps

i see y pin 13 was cut rather than pin 12 because pin 12 and pin 11 would still be connected internally to pin 13

 

[TO4355]

just a quicky

this is the second way it was listed and was proven to work so im going to do it over the weekend for a trial

 

[hakhawk]

looks good, easier that way, dont have to cross resistor over the ic and under knock board, wont take long at all to try out.

lol, poor dick smiths and jaycar will have a runout on 7.5k resistors if this works.

 

[greenfoam]

Hey I just went out for a few hours.......

I see you guys have been very busy!

 

[Chuff]

just a quicky

this is the second way it was listed and was proven to work so im going to do it over the weekend for a trial

I can't see the picture in post #33. If it's there could someone email it to me: [email protected]

Thanks

 

[Doctor Bob]

i have a 4 cyl memcal converted by holden in very early development days to run a v8, havent run it in a car but its still labelled for a v8 from dyno lab at holden
it has cal 56 jumpered to cal 53
rob

 

[hakhawk]

hmm, well, on the 4cyl memcal i got, cal 53 to cal 56 is 15k and cal 58 to 56 is 7.5k.

interesting.

 

[TO4355]

emailed to chuff

 

[Chuff]

Got It.

Thanks.