MY VL wont start..but it cranks over

[etch289]

hello all
i am new here and online member of a couple other auto forums
so-i-give-n-take-help
but
MY GOLD VL sl 6 cyl manual september 1986 built wont start..
but it cranks over ,its always started first shot (and always proud to boast that )but last week it wouldnt start

undid fuel line at rail and seems good pressure coming out
put BRAND NEW timing light on various spark plug & coil leads =no spark
swapped over coil ,REPLACED Crank Angle Sensor brand new............. still the same ,no spark,relay under the fusebox cover clicks on
looked @ computer codes results are 14,23,24,31,32,14
ran test lead from pos batt term to POWER TRANSiStOR on DISt (brown-red wire terminal)
whilst cranking it flashes on-off with,
with key off OR in acc position TEST LIGHT stays on
any help /clues will be much appreciated thanx

 

[spank]

from what you are telling me, and good info by the way, i would say its the crank angle sensor, which is located inside the distributor, not a difficult job and not that expensive really,

 

[etch289]

thanx reply but i have replaced it ,,CAS crank angle sensor brand new couple days ago

 

[etch289]

CODES ARE:
11 Crank angle sensor circuit
12 Air flow meter circuit
13 coolant temperature sensor circuit
14 Vehicle speed sensor circuit
21 ignition signal circuit
23 throttle switch circuit
24 neutral switch circuit
31 satisfactory operation (non air conditioned models) air conditioner circuit (air conditioned models)
32 starter signal circuit
34 detonation sensor circuit (turbo models)
44 satisfactory operation (air conditioned models)
hi thanx reply no i havent .tho i have had the computer out b4
i was also thinking it maybe the little resistor in the wiring loom that runs under the inner RH gaurd ..just opposite the battery

 

[spank]

CODES ARE:
11 Crank angle sensor circuit
12 Air flow meter circuit
13 coolant temperature sensor circuit
14 Vehicle speed sensor circuit
21 ignition signal circuit
23 throttle switch circuit
24 neutral switch circuit
31 satisfactory operation (non air conditioned models) air conditioner circuit (air conditioned models)
32 starter signal circuit
34 detonation sensor circuit (turbo models)
44 satisfactory operation (air conditioned models)
hi thanx reply no i havent .tho i have had the computer out b4
i was also thinking it maybe the little resistor in the wiring loom that runs under the inner RH gaurd ..just opposite the battery

last one i had do this had a faulty fusable link, you need to check battery voltage out of the link with everything hooked up, WHILE CRANKING!!!!!if its less than 12 volts or so the link is ***ed, either that or the ecu has had a meltdown! Also check that the battery terminals are clean and tight and any earths that you can seeif you leave the ignition "on" try moving wiring near the battery and the fusable links, if you hear the relays in the underbonnet fusebox click or buzz then you have a poor connection, thats about all i can think of without having the car with me!!

 

[etch289]

thats about all i can think of without having the car with me!!

whereaabouts are u located spank?????????

disconnected the TPI switch and it sorted of tried to start fire up
and checked heaps of stuff but still the same no start ..................help:bang:

 

[VL Berlina 5speed]

just a random shot in the dark, have you got rust in the left hand side of your windscreen,

maybe water has ran though and soaked your comp causing it to short

 

[etch289]

just a random shot in the dark, have you got rust in the left hand side of your windscreen,

maybe water has ran though and soaked your comp causing it to short

no rust watsoever thouroghly checked that area ..pulled out comp checked all terminals looked as new all dry there even the underlay all dry
thanx tip tho

 

[vlsenna]

hey man did u get the vl going i think i might have the same problem EEEEK !?!

 

[vlsenna]

did ya get ya vl going i think i might have the same problem