Need Help! VZ rear seat into VR...

[-UNKNOWN-]

Hi, searched for about an hour now..
Either theres nothin there or im stupid!

Anyways Im going on the assumption that VT and so on are the same as the VZ seats. Ive done all of the seats but dont know how to get around the rear bottom half. Any help please! Pics would be orsm!

Cheers. UNKNOWN.

 

[simmovxss]

i think there different mate from memory. My vx ss ones are slightly.

 

[-UNKNOWN-]

Anyone? I know people have put VT seats into VNs and so on....

 

[AirStrike]

Can't have searched too hard! Swap the seat frames on the base and it will go straight in.

 

[azkwazere]

ALOT if not all the VT seat threads were lost in the warp... and there were heaps of em...

GOt apic of the bottom of the VZ seat... ive only ****ed around with VT/VX seats so i couldtn tell ya.

aZk.

 

[-UNKNOWN-]

I'll get a pic up after work tonight.

 

[-UNKNOWN-]

Well, here it is...`

 

[azkwazere]

ok mate youve got 2 options:

1. Ive attached an image with a circle in it, That clip needs to be smashed off with a hammer (itll pry with a screwdriver)Youll see a U style hook under that clip, Place a large ass MOFO screw driver into that loop, and bed it clickwise 90Deg.

It will be facing east west insted of north south...

Bend it slightly up(towards the sky) about 10deg.

Reapeat on the other side.

Those new hooks youve just made, will fit onto the floor catches from your old seat. It takes abit of trail and error to get the hook to match the floor hook pattern. Bend a bit, then check etc...

OPTION2:

This is the gay way but ill tell ay anyway.

You need to unhook the seat frame from the seat base.

Then, unhook your VS frame from your VS bench and then atatch it to the base of the VZ seat, itll drop straight in...

This sounds easier but its hard to attach the base again and can be very fiddle, ive done both ways and the 1st is so much easier! and it takes 5mins compared to a half hour!

Good luck!

aZk.

 

[-UNKNOWN-]

Legend, thanks heap mate! Ill get right on it!

 

[-UNKNOWN-]

Its in! Bit of persuasion(sp) and its in!