NV's 04 Z Series Clubsport

[NVMYVT]

well the new clutch and lightened flywheel are in,, and what a difference,, feels so much better and doesn't stink everytime the clutch is used )

also replaced the rear main seal and cover gasket while we had everything out as there was a very slight leak

 

[NVMYVT]

now for the cam upgrade next weekend and tune/otr on Monday and i'm done for mods until after we have paid off debt and finally got our own house and a decent size garage I can house all my cars in

 

[<andy9>]

Sounds good mate. Bet your loving it. That's something I need to is a garage!

 

[NVMYVT]

mine will be getting built properly mate, 3 phase power and a 4 post hoist

 

[<andy9>]

^best way to have it haha. So many times at home I think if only I had a hoist!

 

[NVMYVT]

ok slight update, clutch is in nd it drives so well, cam goes in in two days, but now have the problem of a torn engine mount,,
question is how hard are these to replace in my garage on ramps and jack stands?

 

[NVMYVT]

ok so cam is in and tune has been done, it turned the rollers to the tune of 280rwkw and 675nm of torque
not bad considering it is literally just a cam and tune, with 3.9 diff gears and a cast iron manifold standard cats and standard flow pipes to bring the numbers down from what they should be

 

[NVMYVT]

well it's now sitting with a busted driveshaft and a dodgey one that'll let go soon enough on the other side. lol
time to look into upgrades for them that wont stop them from still being the built in "fuse"