Project Piller Gauges
Project Piller Gauges
Will be adding details to the piller gauge project over the next week or two depending how lazy i decide to be.
For anyone interested in installing a piller pod then this post may or may not help.
Will be easier to tell if my 280xxx engine decides to break down before the worst happens.
The gauges that will be fitted are smoke gauges so the dials are only visable when there is power to the light inside them.
There are two reasons for adding the switches.
1. If? they are too bright for when I am driving at night.
2. So hoons dont see them at night and want to attract some un-wanted attention to this safe driver.
Heres the progress so far.
2" Tripple Piller Pod $27
2" Gauges $15 each X 3
Plastic Paint $16
Switches $2 each X 3
Pod with holes drilled to fit switches.
Negative current switch loom which took 5 minits to solder.
Pod colour-coded to piller.
Pod with switches installed.
Pod & Gauges installed to piller.
Almost ready to go in. Few bits to touch up first.
Will adjust the top one tomorrow.