removing back board in ute

[1jake8]

I have an 08 ssv Ute was just wondering if anyone has instructions in how to remove the back board behind the seats with out breaking anything.
Thanks

 

[VEO55]

Its not a 5 minute job, i will do my best to include everything.

1. Remove front seat rail covers. (Clips)
2. Remove scuff plates. (Clips)
3. Remove B-Pillar panel. (Clips)
4. Remove Qtr glass surround. (2 screws at bottom, 1 screw above seatbelt behind cover)
5. Remove rear scuff plate panel. (Clips... Maybe 1 screw at front)
6. Remove tools from drivers side.
7. Remove battery.
8. Lift the flaps, there are 2 torx screws either side that secure the rear panel to wall.
9. Remove rear panel. (Clips)

 

[1jake8]

Awesome will give it a try tomorrow. After removing this. Ill be able to see the gromet where the wires go from the cabin to the tray? Thanks very helpful

Sent from my HTC One X using Tapatalk now Free

 

[VEO55]

Yeah you will, if you're keen have a look at my thread - https://forums.justcommodores.com.au/threads/ve-ute-extra-storage.211676

 

[1jake8]

Very good write up. Might give it a go

Sent from my HTC One X using Tapatalk now Free

 

['ssv']

If your only doing it to find the grommet, remove the try liner and poke the wires through that way.
Then you wont have to strip the interior.

 

[1jake8]

There are wires already there. Just trying to find out why I'm not getting power

Sent from my HTC One X using Tapatalk now Free

 

[jonesla]

If your only doing it to find the grommet, remove the try liner and poke the wires through that way.
Then you wont have to strip the interior.

does this mean that if i am just putting a wire through to connect to a reversing camera i dont have to take out the onterior and if i drop the wire through where will it appear

 

[Castlo]

The way I did it was to uni the tub liner which is a 5 min job, the six tie downs and two screws at the tailgate, slide it back and you can see the grommets from that side!!!!! Easier than taking apart interior, pro tip use a yellow tongue strip to get the cables between said areas hope this helps

 

[Castlo]

It'll appear Ontop of the battery if using the passenger side, sorry can't send any pics ute got written off by some asshole