Hey BigBoss, I need to remove my diffuser and I have noticed that there are two pin type clips I need to remove which seems easy but how do I remove the two clips from the top of the Difusser. Do I need to access these clips from the boot?
Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.
Where to place car stands when jacking up the rear of a Sedan VE Berlina?
- Thread starter Joey24
- Start date
Chris Ford
New Member
I use four 3 ton, 4-poster chassis stands. These are available from supercheap for under $160. Buy 4 of them...
I've got a 3T jack. I place a piece of ironwood, cut to approximately 1.6M length on the jack, line it up to the door sill on one side of the car. From there, I can raise the car up 500mm.
I set the jacks onto chassis hard points and protect those points with pieces of heavy duty rubber conveyer belting. This stops the chassis having too much point-load and damaging the surface.
Then, you goto the other side and repeat. In about 10 minutes, you have the car sitting safely on stands, approximately 500mm from the ground.
I've got a 3T jack. I place a piece of ironwood, cut to approximately 1.6M length on the jack, line it up to the door sill on one side of the car. From there, I can raise the car up 500mm.
I set the jacks onto chassis hard points and protect those points with pieces of heavy duty rubber conveyer belting. This stops the chassis having too much point-load and damaging the surface.
Then, you goto the other side and repeat. In about 10 minutes, you have the car sitting safely on stands, approximately 500mm from the ground.