glove box removal

[viccib]

Hi can anyone tell me how to take a glove box out of a VY SV8 sedan?? also, is it the same as a VZ executive sedan? thanks

 

[Big-Al]

PM sent with link to the service manual for VT - VY2. Should be the same process for the VZ.

 

[hotrod]

very simple on the inside right side pop out the plastic pin , that's it .

 

[Sabbath']

very simple on the inside right side pop out the plastic pin , that's it .

Nope.

Wrong...for a change.

 

[hakhawk]

Hi can anyone tell me how to take a glove box out of a VY SV8 sedan?? also, is it the same as a VZ executive sedan? thanks

yes, vy and vz glovebox removal are the same

 

[Group C]

And if you break the clips that hold the lid Holden normally have in stock for a Cpl dollars

 

[viccib]

but can anyone tell me how to do it though??? thanks too

 

[mark_1000]

I know if this is the correct way to do it, but i just pull in the little rubber stoppers on the sides to allow the door to go lower than it's supposed to, and then just pull on the glove box door directly towards you if you're sitting in the passenger seat.

 

[hakhawk]

sorry, seeing as you asked if it was the same as on a vz, i assumed you had done a vz before.

1. open glovebox
2. remove anything inside glovebox, or itll do it for you at step 4
3. remove 2 rubber stoppers by pushing them towards the front of the car and inwards, they just slide off.
4. open glovebox further, at this point if you forgot to remove everything, it will fall out onto the car floor.
5. pull towards you on both sides. take your time, dont be too forceful or you will break the plastic clips, but if you do they can be easily sourced from holden as said above.

 

[viccib]

thank you so much, very much appreciated