Low idle VS ute v6 in Drive and poor fuel economy

[VH commodore]

check the vacuum hose that goes from the bottom of the trottle body under the inlet manifold, they always pop off and will cause rough idle etc

 

[VPbomb]

check the vacuum hose that goes from the bottom of the trottle body under the inlet manifold, they always pop off and will cause rough idle etc

Double checked and replaced with a new hose and clamps few months ago just in case.
Cheers

 

[VPbomb]

Okay, reading around on this forum, I think my cutting out issue (and not cranking until being jump started when hot after stalling) might be the Crank Angle Sensor. There are no error codes at all even on efilive straight- had PC/cable plugged in after I re-started this when it stalled.
Not sure if the CAS can also cause idleing issues when in drive, so will look into this as hopefully it's my ideling issue aswell...

 

[The1]

most of the time a faulty CAS wont log an error.

 

[The1]

here's the xml for efilive v4 i have been working on. It should all work correctly, let me know if you find problems.

http://www.eyeit.org/holden/VS_CommoV6.zip