Urgent help!

[BowTie]

.

 

[Immortality]

Only one thread per topic as per the forum rules.

Threads merged!

 

[Walshy3551]

Factory manual or conversion?

Conversion

 

[Grimes]

Conversion

What fault codes came up (the paper clip trick)?

 

[Immortality]

Conversion

Has the tune be altered to suit a manual trans. Has the speedo signal been fixed?

 

[Walshy3551]

Have you checked error codes ?
Use the paperclip trick https://forums.justcommodores.com.au/threads/checking-error-codes-vr-vs-revised.22307/

I have no clue what to do and what’s right

 

[Grimes]

I have no clue what to do and what’s right

Follow the instructions in the link by bridging these two with a paper clip wire with the ignition on. Code 1-2 will flash three times then your first error code, followed by any others.

 

[Walshy3551]

Follow the instructions in the link by bridging these two with a paper clip wire with the ignition on. Code 1-2 will flash three times then your first error code, followed by any others.

I got engine code 94

 

[Grimes]

I got engine code 94

The ECU isn’t getting a speed signal from the transmission. When you converted, did you replace the ECU with one that’s matched to the gearbox? Automatics, T5 and Getrags have their own ECU program/tune to accept the different signals received.

Check to make sure the speed sensor is still connected to the transmission too. It’s held on with a small hex screw.

The sensor cable also has a white plastic inline connector that will be just inside the trans tunnel. Make sure it’s still connected too.

 

[Walshy3551]

The ECU isn’t getting a speed signal from the transmission. When you converted, did you replace the ECU with one that’s matched to the gearbox? Automatics, T5 and Getrags have their own ECU program/tune to accept the different signals received.

Check to make sure the speed sensor is still connected to the transmission too. It’s held on with a small hex screw.

The sensor cable also has a white plastic inline connector that will be just inside the trans tunnel. Make sure it’s still connected too.

I’m not too sure how to do all of this hey I’m still new to this