Red LS1 V8
Member
I am looking to hard wire a Bluetooth adaptor in my VYII.
I've read that there's a mobile phone port on the passenger side of the centre console in VY's. You can get a Holden plug that fits mobile phone port. This plug was used in the old days to wire in aftermarket mobile phone kits.
My reading shows that the Holden plug has the following pin wire inputs:
Pin 1. Orange - 12V Supply (Battery via fuse... always on)
Pin 2. Black/Green - 0V (Chassis, earth, ground).
Pin 3. Yellow - 12V Accessory Supply
Pin 4. Yellow w/stripe - Radio Mute signal. Active Low.
Pin 5. Blue w/stripe - Audio-
Pin 6. Blue - Audio +
The cable from my Bluetooth adaptor has a black wire for ground, and a red wire for switched 12v power.
So, I could simply wire the Holden plug (via the spade connectors used for the mobile phone kits) as below:
Bluetooth adaptor red wire into Pin 1 - Orange.
Bluetooth adaptor black wire into Pin 2 - Black/Green.
All the other pins on the Holden plug remain empty.
Can anyone see any issues with this?
Thanks
I've read that there's a mobile phone port on the passenger side of the centre console in VY's. You can get a Holden plug that fits mobile phone port. This plug was used in the old days to wire in aftermarket mobile phone kits.
My reading shows that the Holden plug has the following pin wire inputs:
Pin 1. Orange - 12V Supply (Battery via fuse... always on)
Pin 2. Black/Green - 0V (Chassis, earth, ground).
Pin 3. Yellow - 12V Accessory Supply
Pin 4. Yellow w/stripe - Radio Mute signal. Active Low.
Pin 5. Blue w/stripe - Audio-
Pin 6. Blue - Audio +
The cable from my Bluetooth adaptor has a black wire for ground, and a red wire for switched 12v power.
So, I could simply wire the Holden plug (via the spade connectors used for the mobile phone kits) as below:
Bluetooth adaptor red wire into Pin 1 - Orange.
Bluetooth adaptor black wire into Pin 2 - Black/Green.
All the other pins on the Holden plug remain empty.
Can anyone see any issues with this?
Thanks