Guide to New Lead Install For VN SS 5.0L

[RVN 355]

hey guys i need the firing order for holden 304 5 litre and labeled diagram how the dizzy ie which cylinder is for what on leads.... thanks

 

[Boonz]

1,2,7,8,4,5,6 i think.... its written on the manifold anyway so correct me if im wrong

 

[greenfoam]

It'll cost you , I'll have a look for it

 

[Boonz]

lol i know the first 4 are right

 

[RVN 355]

ok new leads are on thanx for the pics and info guys

I got TOP GUN 8.8mm RED Spiral Core - when i hold 3 k @ idal the car dies and i gota start it up any ideas guys? stall convertor?


304 5litre FIRING ORDER 1278456

 

[RVN 355]

Guide Leads For 5 Litre

Guide to Installing New Leads for the 5.0 Litre

Start from the back off the block, do one lead at a time lol Thanks BOONA 15 :thumbsup: make sure u line up each lead to the dizzy then the dizzy lead to the coil....

All Leads should be tight on the plugs and click on and keep leads away from manifold or hot parts of engine...

8.8mm leads are good for igniting both lean and rich fule mixtures,reducing miss fire that can occur under heavy load... suitable for ECU,msg ignition, rev limited Engines

TOP GUN - PRO RACING SPIRAL WIRE 8.8mm and 10.0mm

Double insulated, high temperature cable (250°C plus). Features a reinforced fibreglass braid interwoven between the layers of silicone insulation. The conductor utilises a spirally wound stainless steel construction, in which a single stainless steel wire is helically wound around either a ferrite or kevlar carrier. This conductor has good RFI suppression qualities, with a resistance of between 2,000-2,700Ω per metre length. Uniquely suited for performance applications, for both race track and street applications. (WWW.TOPGUNLEADS.COM.AU)

 

[greenfoam]

And make sure the engine is cooled down because sure enough you are going to have to lay on it to plug some of them in

 

[RVN 355]

Dizzy Brands

For a upgrade consider MSD or Crane Cams


Crane Cams: Street/Race Distributor

The ultimate in distributor ignition firing accuracy!
For street or all-out race
Accurate to +/- .5 degrees at all RPM levels!
Magnetic trigger plug works with most Crane Cams Ignitions plus many others
9 electronically pre-programmed ?mechanical? advance curves3 electronically pre-programmed ?vacuum? advance curves
Zero position provides advance lock-out for crank trigger ignitionsPhoto-etched, stainless steel trigger disc eliminates flex and corrosion
Aircraft quality upper bearing for long life, precision alignment
Adjustable slip collar (GM apps) for machined block heights
Billet 6061-T6 aluminum housing
Composite lower housing bearing holds true alignment
Precision M-A-P sensor built-in
Solid brass cap terminals ensure maximum current conductivity
Fully urethane sealed against dirt, oil, and moisture.
Surface mount robotic assembly for accuracy? same as used in laptops a...

 

[AirStrike]

Anyone know the part or model number for the MSD dizzy to suit a VN 5.0l?
AirStrike :air:

 

[RVN 355]

not sure i found info about the crane one on there website, but ill find out about the msd one