Search results

Only VT's and up have 2 cooling fans.

They are brand new leads and as I have said there is spark from the leads as I got shocked afew times checking them even with rubber gloves on. I have just been thinking that the spark plugs are quite old and the ground electrode might be worn on the tip so its not sparking properly. I will...

Hey ppl, I have a high idle problem with my VS for starters but when I reset my computer and reset the IAC valve to 28mm my car is now missing, I have checked for spark and I has plenty of it. I know the IAC valve is stuffed but It wasnt missing before I tested it. The IAC valve shouldnt have an...

come on guys, make an offer.

ITEM: VT V6 heads, tappet covers, injectors and fuel rail, intake manifold, plenum chamber and throttle body. LOCATION: QLD, Brisbane CONDITION: Used, take off engine with unknown km's, still has original spark plugs PRICE: $250ono for the lot or make an offer on seperate pieces...

Sweet, thanks guys. I figured I would need a different computer and stuff but wasnt too sure if the gearbox from the VR would bolt up to a VS. Cheers guys, Thanx for the help.

Hey guys, Does anyone know if a T5 gearbox out of a VR V6 will fit a VS V6???

Hey mate, Will the Lvl 3 dash and adapter fit a VS. Cheers TJ

It's just the uni joint, any mechanic could do it or you could give it a shot if you have a vice, circlip pliers, hammer and a gregory's manual would help aswell. Cheers TJ P.S what were you doing when it broke???

Here is mine, got it done last year just before new year's

where are you located?

Im not sure but I dont think that it is possible, if it is possible it would require a lot of work.

Yeh, the same thing with the new prado's and landcruisers

lol, poor guy in the jeep, he actually manages to not slide on the ice but still gets rear ended. He must of been so pissed. And the truck trying to divert traffic has the arrow facing the wrong way, lol.

Ipec or Toll are usually pretty good to use.

Thats wat I thought too, but once while I was goin up a hill in the wet I did get a slight bit of wheel spin as it changed down gear while the cruise control was on. it did correct itself almost straight away but it did give me a slight fright.

I have used cruise control in wet weather and never had any probs, I was always concerned that something like that could happen as my car loves to spin the rears in the wet. I think I will take this into consideration next time im on the motorway and its raining (even tho thats not very likely...

If its not too loud it could just be ur injectors, if not its ur tappets, put some engine flush through it and give it a service.

hey thomas1, you wouldnt happen to have the dimensions for your box would you??? Cheers TJ

Hey man, Could you post some pics when you are finished installing the water pump?? Im a little interested to see it setup. Cheers TJ

Could you find out how much postage would cost to QLD(4301) Cheers TJ

could you find out how much to post to Queensland (4301). Cheers TJ

hey mate, where are you located? Cheers TJ

Im pretty sure the first VS's came out around april 95

It's the old buick V6 in a FWD car, lol, first time I have seen that. I wonder what car it is?

I put my piston in yesterday and I am very happy with the results, its not that hard to do but can get very annoying putting the e-clip and circlip back in as you have very little room to work. I should be getting the boost valve next week as well so I will tell you how much of a difference it...

I would go for the SLR if its in good condition...V8 manual, black with 19's, now that would look nice and be so much fun to drive.

OHC and DOHC engines are good for higher revving engines but for a V8 I would rather a low revving engine with plenty of torque which is what you get from OHV engines... but thats just my opinion

Sounds like your springs are sagging abit mate.

I doubt that it's the air temp sensor...My car runs fine with it unplugged, runs a little bit richer but thats about it.

Extractors, 2.5in exhaust, 1.97-1 Roller Rockers, 70mm throttle body, CAI ,K&N panel filter and a decent tune should get you pretty close to the 200KW @Fly, If not get the heads ported and a decent cam will get you there.

I just got 1 off ebay and am goin to fit it in the next couple of weeks, I asked the guy at Trick Shift and he said if you know your way around a car it shouldnt be a problem to do yourself.

you could just get a spray tint from autobahn and use them on your tailights, I did it to mine and it looks alright, plus I havent seen any other Vr or VS in my area with it done

Hey shumway, nice car mate, just wondering where you got the 70mm TB from??? Cheers

hey man, I just got my vs (IRS) lowered with low king springs and I still have the standard shocks, I will get around to taking a photo for you soon. If you do get lowered springs try and get new strut bearing plates as my RH side one became very noisy after putting the springs in. The car...

can I get them delivered to QLD?

I got a full set of genuine HSV floor mats for my brothers senator from holden for about $160

WTB a VL turbo engine or turbo kit for a VL

Hey guys, I've got a Vl motor and I'm considering pulling the motor down it to check its condition and rebuilding it with the intensions of putting a turbo on it, can the stock N/A bottom end be used with a turbo or do I need to rebuild the bottom end with something a little stronger???. Any...

Thats correct, you will have to take it to some one with a diagnostic machine and get it tuned