Search results

service reminder yes remember it is a reminder only and should appear when the km read 1000 km less eg 190ooo service due will flash on startup when she is 189000 and keep reminding until this is cleared manually by the above method. it wont allow you to change the digits of service, goes up by...

point is fixed her without a mechanic and or bench press.....well its the next day and replaced inner control arm, serviceable 2nd hand control arm had ball joint riveted on so i used that one looked better anyway, replaced whole strut assy as mine had a torn boot, replaced z bar bushing at the...

lower control arm front well its a week later and have time to start , gone a different path now, ive bought a complete arm with balljoint and good bushes already in it, second hand so its easy now I hope, altogether spent 55 for arm and 40 for radius rod bushes at the front of z bar , also...

i reckon if you didnt see the flash you should be ok

:undead::undead::undead::rofl2:thanks, bush inner control arm lower front prices are not too bad but i found big difference one shop 60 a pair and a well known suspension specialist said 140 he will press it out and in for me, but ebay is cheapest yet 40 plus post, the abs hub, thanks for...

yes i have left and right bearing hub second hand came with struts, i bought last night by bad decision, now not needed, it was only the bush on control arm and one hub which i bought separate. has abs wire was going to list on ebay, some new ones are dear and could be fakes from china...

vr steering what needs to happen is car jacked up with 2 stands , and have a good look while turning the hub and disc see if any movement in lower control bush where it pivots in the frame inner bush there may be chewed out, if so remove lower control arm and get the old bush pressed out, or...

just replaced front wheel bearing hub vr my car vr non abs with non irs. not too hard with the help here, only needed one trip extra to buy 10 mm hex socket for the 3 capscrews also a breaker bar got away with 3/8 drive as one screw bit limited for space even when hub is turned, anyway my...

dash guage cluster yes annoying banging the top, since changing my cluster have no probs, it was a good one, must be heaps of shoddy ones still getting sold 2nd hand, the green sheet on back is most important, check for scratches in tracks, broken circuits, have to use multimeter check pin 11...

my vr on lpg 350 000 ks did same thing , my valves no problem, use uper cyl lube and run petrol sometimes, dont overlook all the electrical components concerned, start with coil pack, cas, even oxy sensors but i didnt need them, only the coil pack helped me, does it have an annoying flat spot...

look at injector rail on pass side at the back a hose connection held by 5 mm allen screw, and a oring special from holden its fuel resistant only small part they were $2 a few years ago, now $8 for one oring, if the leak is there you can feel the petrol around connection, its an easy fix once...

....2 hours later, job done it works, lucky me, saved 50 on a new cluster , i scraped between two good points on faulty track, multimeter a must, and foiled it , taped it checked circuit , and sppeedo now works, odometer works thanks to new gear under stepmotor easy to do tricky part is speedo...

speedo not working the damage to track 11 con 2 is same as mine but underneath, while i was careful taking cluster out and in , the problem was i did it 10 times kept checking speedo taking things apart, the needle part i thought i may have disturbed calibration when removing it, but this has...