paulthehutt
New Member
- Joined
- Feb 20, 2015
- Messages
- 2
- Reaction score
- 0
- Points
- 0
- Location
- woodville
- Members Ride
- 2006 holden barina
Hi forum users,
Just after some advice regarding my partners 2006 barina.
I have just replaced the thrust bearing as the old one was shot.
On reassembling and testing the only gear i can get the car to move in is reverse.
I can select a few other positions but they all lock up the gearbox when i release the clutch.
I did not pull the gearbox apart at all except from removing the drive shafts and pulling it off the engine to replace the bearing.
I have tried readjusting the position of the selector into a few different positions but it hasn't made a difference.
Its got me really confused.
Any input would be greatly appreciated.
Just after some advice regarding my partners 2006 barina.
I have just replaced the thrust bearing as the old one was shot.
On reassembling and testing the only gear i can get the car to move in is reverse.
I can select a few other positions but they all lock up the gearbox when i release the clutch.
I did not pull the gearbox apart at all except from removing the drive shafts and pulling it off the engine to replace the bearing.
I have tried readjusting the position of the selector into a few different positions but it hasn't made a difference.
Its got me really confused.
Any input would be greatly appreciated.
Last edited: