gasket between 202 exhaust and inlet manifold?

[griezy]

If they are to suit the VH listed as your members ride...……

You can get them as a set of 3.....AA Gaskets Part# JC396
https://www.ebay.com.au/sch/i.html?...leDesc=0&_osacat=0&_odkw=HA368&LH_TitleDesc=0

Or you can get them as a set with the manifold gasket.....AA Gaskets Part# HA368
https://www.ebay.com.au/sch/i.html?...leDesc=0&_osacat=0&_odkw=JC396&LH_TitleDesc=0

thanks Tonner Matt much appreciate it, i was typing in the wrong thing to search (black 202 inlet exhaust manifold gaskets) nothing came up

 

[rambunctious]

FWIW, if you need to block holes or simply tidy up, the cast iron exhaust manifolds can be easily welded either with tobin bronze rod and oxy, or with cast iron rods in a good old arc welder.
In the 60's I used to cut the centre out of the cast manifolds and weld a flat plate onto each section to make them into headers.

 

[Lunati]

out of interest, the 26-23 webber works really well on a 202. A 350 holley is a bit to large to be really effective. BUT if you put venturi sleeves, you can jet the holley right back (memory is telling me about 46) and they work perfect, Good power and great economy (but not at the same time lol)
Ive even done a couple of 350's that had a primary and secondary set up. But at the time when we were doing all this, they were hard to get.